解算器

面板

Physics ‣ Soft Body ‣ Solver

The settings in the Soft Body Solver panel determine the accuracy of the simulation.

最小步阶尺寸

Minimum simulation steps per frame. Increase this value, if the soft body misses fast-moving collision objects.

最大值

自动步长

Use velocities for automatic step sizes. Helps the Solver figure out how much work it needs to do based on how fast things are moving.

错误限额

Rules the overall quality of the solution delivered. The most critical setting that defines how precise the solver should check for collisions. Start with a value that is half the average edge length. If there are visible errors, jitter, or over-exaggerated responses, decrease the value. The solver keeps track of how “bad” it is doing and the Error Limit causes the solver to do some “adaptive step sizing”.

将性能打印到控制台

Prints on the console how the solver is doing.

Estimate matrix, split to , , .

辅助器

These settings control how the soft body will react (deform) once it either gets close to or actually intersects (cuts into) another collision object on the same layer.

阻塞

Calms down (reduces the exit velocity of) a vertex or edge once it penetrates a collision mesh.

模糊

Fuzziness while on collision, high values make collision handling faster but less stable. Simulation is faster, but less accurate.