笔画

Line Style: Strokes.

端点样式

You can choose between three types of line caps:

• 底盖

  Flat cap, exactly at the point the line ends.

  圆(四舍五入)

  A half circle centered on the end point of the line.

  正方形

  A square centered on the end point of the line (hence, like the circle, the drawn end of the line is slightly extended compared to its computed value).

Line caps example.

By default all retrieved lines from the line set are chained together. There are two basic chaining methods:

方法

Same Object

If true, only feature edges of the same object are joined.

You can split up chains of Freestyle lines by enabling one of the following:

Min/Max 2D Angle

Splits chains of feature edges when they make a 2D angle above (or below) a minimum (or maximum) threshold.

2D 长度

Splits chains when they are longer than the given value.

材质边界

Splits chains of feature edges if they cross from one material to another.

Splits the chains using the given dashed pattern (see also Dashed Line).

Dash 1, 2, 3

Length of the specified dash for splitting.

Gap 1, 2, 3

Length of the specified gap for splitting.

You can sort the order of your strokes, allowing the lines to stack in the order given.

排序键

A sort key is used to determine the stacking order of lines.

• 到相机的距离

  Lines closer to the camera lie on top of further lines.

  2D 长度

  Longer lines lie on top of shorter lines.

  Projected X/Y

  Sort by the projected X or Y value in the image coordinate system.

插值类型

• 平均值

  The mean of the values obtained for the vertices.

  最小值

  The minimum of the values obtained for the vertices.

  最大值

  The maximum of the values obtained for the vertices.

  起始点

  The value obtained for the first vertex.

  结束点

  The value obtained for the last vertex.

排序次序

With the given result you can choose to “Reverse” the sort order.

You can also choose to only render selected chains.

Min/Max 2D Length

Chains longer and/or shorter than 2D Length.

链总数

Allows the selection of first N chains.

By enabling the Dashed Line checkbox, you can specify three pairs of dash and gap lengths. Dash values define the lengths of dash strokes, while gap values specify intervals between two dashes.

If a zero gap is specified, then the corresponding dash is ignored even if it has a nonzero value.

Dashes are treated as separate strokes, meaning that you can apply line caps, as well as color, alpha and thickness modifiers.

Dash 1, 2, 3

Length of the specified dash for dashed lines.

Length of the specified gap for dashed lines.