Linear Radial Axis
The following additional configuration options are provided by the radial linear scale.
The axis has configuration properties for ticks, angle lines (line that appear in a radar chart outward from the center), pointLabels (labels around the edge in a radar chart). The following sections define each of the properties in those sections.
Tick Options
The following options are provided by the linear scale. They are all located in the ticks
sub options. The options are supported by this axis.
The suggestedMax
and suggestedMin
settings only change the data values that are used to scale the axis. These are useful for extending the range of the axis while maintaing the auto fit behaviour.
In this example, the largest positive value is 50, but the data maximum is expanded out to 100. However, because the lowest data value is below the suggestedMin
setting, it is ignored.
In contrast to the suggested*
settings, the min
and max
settings set explicit ends to the axes. When these are set, some data points may not be visible.
Step Size
This example sets up a chart with a y axis that creates ticks at 0, 0.5, 1, 1.5, 2, 2.5, 3, 3.5, 4, 4.5, 5
.
The following options are used to configure angled lines that radiate from the center of the chart to the point labels. They can be found in the angleLines
sub options. Note that these options only apply if is true.
Point Label Options
The following options are used to configure the point labels that are shown on the perimeter of the scale. They can be found in the pointLabels
sub options. Note that these options only apply if pointLabels.display
is true.